Tungsten Carbide Sharpening Faceplate & Disc 1/4 x 8 thread

WTF90-45 
This 100mm diameter faceplate is designed to take a 100mm sharpening disc, which is specifically designed for sharpening carbide cutters.
 
This is for Wooden Faceplate sharping disc not included
 
Alternatively, we can create one that is resin infused for you. We offer three thread options:
Link to our wooden faceplates
 
1/4 x 8" - Suitable for lathes with this spindle thread, including Nova, DVRXP, DVR SATURN, NOVA 1624, HARVEY, NOVA ORION, and Neptune.
33 x 3.5" - Suitable for lathes with this spindle thread, including Record Power lathes.
1" x 8" - Suitable for lathes with this spindle thread, including Nova Comet 1 and 2, Comet DR, Tooline, Delta, Jet General.
 
Instructions for use:
 
YouTube video link
https://youtu.be/9V7t_uy9QY8?si=X5xQW-gynkxS_uhQ
 
Set your faceplate and sharpening disc on the lathe at 300 rpm.
Mount the cutter in your battery-powered drill using the shaping dowel provided with the tool.
Spray a small amount of water on the disc.
Run the drill in the opposite direction of the lathe while touching the heel/bevel of the cutter's face to the wheel.
Move the drill towards the lathe's headstock until the cutting edge touches the disc.
It's helpful, especially when starting, to mark the entire cutting surface of the cutter with a permanent marker pen to see what you're sharpening clearly.
A useful tip is to run the cutting edge over your fingernail. If it shaves off a piece, it's still not sharp enough; it should dig in immediately