WTF90-45 Carbide Cutter Sharpening Faceplate & Disc 1/4 x 8 thread

Sharpen your carbide cutters with precision using our WTF90-45 sharpening system. This 100mm diameter disc and wooden faceplate combo is specially designed for effective and consistent sharpening of carbide cutters used in woodturning tools.
 
What’s Included:
100mm Sharpening Disc
Wooden Faceplate (three thread options available)
This resin-infused wooden faceplate is ideal for enhanced durability and performance.
 
Faceplate Thread Options:
1¼" x 8 TPI – Compatible with Nova, DVR XP, DVR Saturn, NOVA 1624, HARVEY, NOVA Orion, and Neptune lathes
 
M33 x 3.5mm – Fits Record Power and other European-standard lathes
1" x 8 TPI – Suitable for Nova Comet 1 & 2, Comet DR, Tooline, Delta, Jet, and General lathes
 
Instructions for Use:
 
📺 Watch our demo video:
Sharpening Carbide Cutters on a Lathe – YouTube
 
Mount the faceplate and sharpening disc onto your lathe. Set lathe speed to 300 RPM.
Insert your carbide cutter into the sharpening dowel and place it in a battery-powered drill.
Lightly spray water on the disc surface.
Run the drill in the opposite direction of the lathe while gently pressing the cutter's heel/bevel to the disc.
Gradually move the drill toward the headstock until the cutter’s cutting edge contacts the disc.
For better accuracy, mark the cutter’s face with a permanent marker to track your sharpening progress.
Sharpness tip: Lightly touch the cutter's edge to your fingernail — if it shaves, it's not sharp enough; it should bite in immediately.
 
✅ Ideal for hobbyists and professional woodturners alike
🛠 Designed for easy, repeatable sharpening
💧 Wet sharpening helps keep the cutter cool and improves results
Have questions? Contact us