TCT 3000g Diamond Sharping Disc
$28.00Price
GST Included
This 100mm diameter, 3000g sharpening disc is designed for sharpening carbide cutters. To use it, create a wooden flat 100mm faceplate with a 16mm tenon that fits the disc's hole. Secure it with a large washer and screw, and remember to seal the timber as it will be getting wet.
Alternatively, we can create one for you. We offer three thread options:
Link to our wooden faceplates
- 1/4 x 8" - Suitable for lathes with this spindle thread, including Nova DVR 3000, DVRXP, DVR SATURN, NOVA 1624, HARVEY, NOVA ORION, and Neptune.
- 33 x 3.5" - Suitable for lathes with this spindle thread, including Record Power lathes.
- 1" x 8" - Suitable for lathes with this spindle thread, including Nova Comet 1 and 2, Comet DR, Tooline, Delta, Jet General.
Instructions for use:
- Set your faceplate and sharpening disc on the lathe at 300 rpm.
- Mount the cutter in your battery-powered drill using the shaping dowel provided with the tool.
- Spray a small amount of water on the disc.
- Run the drill in the opposite direction of the lathe while touching the heel/bevel of the cutter's face to the wheel.
- Move the drill towards the lathe's headstock until the cutting edge touches the disc.
- It's helpful, especially when starting, to mark the entire cutting surface of the cutter with a permanent marker pen to see what you're sharpening clearly.
- A useful tip is to run the cutting edge over your fingernail. If it shaves off a piece, it's still not sharp enough; it should dig in immediately.